Reading and setting the LIS-SE

 

If the LIS-SE is not preset or the settings need to be adapted, the corresponding parameters must be adjusted.

 

Further chapters at a glance:

P 0.0 Maximum load capacity

P 0.1 Maximum load capacity of hoist 1

P 1.1 Motor type

P 1.2 Winding resistance

P 1.3 Current correction factor

P 2.1 Setting slow lifting speed

P 2.2 Setting fast lifting speed

P 2.3 Setting with test load (teach-in)

P 2.4 Device diagnosis

P 3.0 Load display

P 3.1 Rotating field power

P 3.2 Load display with deactivated overload protection

P 3.3 Motor current

P 3.4 Mains voltage

P 3.41 Mains voltage analysis

P 4.0 Load-controlled switching point

P 4.1 Switching point of overload protection of hoist 1

P 4.2 Second load-controlled switching point

P 4.3 Without function

P 4.4 Operation on twin hoists

P 5.0 Measuring time extension

P 5.01 Sensitivity of “rapid load increase”

P 5.1 Theoretical service life

P 5.2 Load population recorder

P 5.3 Test at the inspection before initial commissioning

P 5.4 Inching counter

P 5.5 Deleting values

P 6.1 Starting value

P 6.2 Actual hours of use S

P 6.3 Operating hours Ti

P 6.4 Input of theoretical service life

P 6.5 Deleting values (including load population recorder)

P 7.0 Password input for parameter level 3

P 9.9 Exiting the parameter level