With this parameter you enter the ohmic resistance of the winding for the fast and slow lifting speeds. The winding resistance [in ohms] is measured directly on the motor or on the central control at contactor K23.

Opening/reading parameters

   Select parameter P 1.2 with the arrow buttons.

   Press Enter briefly.

●   The parameter is opened.

●   The value of the winding resistance at slow lifting speed is displayed.

   Press Enter briefly.

●   The value of the winding resistance at fast lifting speed is displayed.

   Press Enter briefly.

●   “└ - -” is shown in the display.

   Press Enter briefly.

●   Parameter P 1.2 is displayed.

Setting parameters:

   Select parameter P 1.2 with the arrow buttons.

   Press Enter briefly.

●   The parameter is opened.

●   The current value of the winding resistance at slow lifting speed is displayed.

   Press Enter briefly.

●   The current value of the winding resistance at fast lifting speed is displayed.

   Press Enter briefly.

●   “└ - -” is shown in the display.

   Hold Enter pressed until “Code” appears in the display.

   Hold Enter pressed.

   Enter code 1443.

   Press Enter briefly.

   Enter the first value of the resistance [in ohms] for the slow lifting speed using the arrow buttons.

   Press Enter briefly.

   Enter the second value of the resistance [in ohms] for the fast lifting speed using the arrow buttons.

   Press Enter briefly.

●   The values are saved.