The qualified person inspecting the crane is responsible for the type and scope of the test.

In addition to the points described here, all points outlined in the other supplied product manuals must also be checked.

The decision as to whether the EHB-I is in perfect condition may be made only by the person inspecting it. Any inadequacies, if found, must be eliminated. The examiner decides whether the crane has to be tested again afterward.

If locally applicable regulations specify further tests, these are likewise to be carried out.

Additionally, at least the following points must be checked:

    Check travelling gear bolt. See Checking the travelling gear bolt.

    Check the clearance between wheel flange and rail on the crane trolley. See product manual “Push trolley HF / Electric trolley EF”.

    Inspect bolts and SL safety clips. See Inspecting bolts and SL safety clips.

    Check hoist trolleys. See Inspecting trolleys.

    Check crosshead HB11. See Check cross bar HB10/HB11.

    Only with trolley drive: Inspect HBF drives. See Checking the HBF trolley drives.

    Only with trolley drive: Check brake on trolley drive. See Checking the brake on the trolley drive.

    Inspect end caps on the HB profile rails. See Inspecting end caps.

    Inspect profile joints. See Inspecting profile joints.

    Inspect conductor system. See Inspecting the conductor system.

    Check the bearing disc in the crane girder suspension. See Checking the bearing disc in the crane girder suspension.