In order to put a replacement transmitter into operation, the address of the faulty transmitter must be entered in the replacement transmitter.
|
|
Danger due to different transmitters! If a non-identical transmitter is used as a replacement, the control commands might not correlate with the labelling. This can result in accidents with the crane. Only use identical transmitters as a replacement. |
The wireless technologies XR0 and XR2 are available for ABURemote.
─ Transmitter and receiver must both use the same wireless technology (both XR0 or both XR2). A transmitter with wireless technology XR0 cannot be used with a receiver with XR2 and a transmitter with wireless technology XR2 cannot be used with a receiver with XR0.
─ Several radio remote controls (combination of transmitter and receiver) with wireless technology XR0 and XR2 can be operated in parallel without any problems, e.g. within a building.
─ A radio remote control (combination of transmitter and receiver) with wireless technology XR0 can generally be exchanged for a radio remote control with wireless technology XR2.
To find out which wireless technology is used on the radio remote
control:
─ Observe
the type plate on the transmitter or the receiver:
Without further
specification: wireless technology XR0
With specification “XR2”: wireless
technology XR2
─ Or read the wireless technology in the menu item “Info”. See Displaying transmitter information.
Log out the defective
transmitter from the receiver.
─ Log out the transmitter either per menu or direct access button. See Logging out and switching off the transmitter.
─ Or, if the transmitter is no longer available for example, switch off the crane and then switch it back on again. This switches off the receiver and the transmitter is automatically logged out.
Find out the address that was
set on the defective transmitter.
─ Read off the address in the menu item “Info” on the defective transmitter. See Displaying transmitter information.
─ Or, if the transmitter is no longer is available for example, read off the address from the type plate of the receiver.
Set the same address on the replacement transmitter that was set on
the defective transmitter. See Setting the address
(linking transmitter to a receiver).
Switch the transmitter off,
remove the rechargeable batteries briefly and then reinsert them, switch the
transmitter back on again.
● The replacement transmitter can now be used.
