To check the brake, the reference gap between the brake bearing shield and anchor plate is measured, as well as the brake lining thickness.

A step (for the O-ring) makes the air gap (distance between brake bearing shield and anchor plate) difficult to access. Therefore a reference gap is measured outside on the motor in order to obtain information on the width of the air gap.

Overview:

If the reference gap is wider than permitted, the brake must be readjusted. If the minimum brake lining thickness is reached, the fan blade with brake lining must be replaced.

If the width of the reference gap is within the permitted range but usage behaviour leads to the expectation that the reference gap will be wider than permitted before the next regular inspection, the fan blade with brake lining must be replaced now.

   Take off the fan cover.

   Measure the distance between brake bearing shield and anchor plate.

   If the reference gap is larger than 3.7 mm: Adjust the brake. See Adjusting the air gap at the brake on the drive with the helical gear unit.

   Check the thickness of the brake lining with a calliper.

If the brake lining is less than 2 mm thick: replace the fan blade with brake lining.

The area between the brake bearing shield and the anchor plate (reference gap) is protected from dust by an O-ring. The O-ring must not become damaged or missing.

   Check the O-ring (between brake bearing shield and anchor plate).

The O-ring must not be torn, dented or damaged in any other way, nor be missing completely.

If the O-ring is damaged or missing, fit a new O-ring.

   Attach fan cover.

Distribution or reproduction of this document, or the utilisation and disclosure of its contents without express consent is prohibited. Violations will result in liability for damages. All rights are reserved in regard to patent issuance or registered designs.