Inspecting the fixed point crosshead

Only with wire rope hoist with hoist drive GM 800 to GM 3000 with reeving 2/1 or 4/1

On a wire rope hoist with hoist drive GM 800 to GM 3000, the fixed point crosshead is fitted on bearing bushes using bolts and SL safety clips.

 

Bolt with SL safety clip	Bolt with SL safety clip
Rope socket with rope wedge and dead end rope grip	Fixed point crosshead

   Inspect the fastening. The fixed point crosshead must be securely fastened and all bolts must be secured with SL safety clips.

   Inspect the fixed point crosshead.

The drilled holes and the lower opening must not exhibit any cracking or other damage.

   Check bearing bushes for damage. The bearing bushes must not exhibit any cracking or other damage.

   If components are missing or damaged: replace the components.

See Exchanging the fixed point crosshead with rope socket and rope wedge.

 

 

Only with wire rope hoist with hoist drive GM 5000 to GM 7000 with reeving 2/1, 4/1 or 6/1

On a wire rope hoist with hoist drive GM 5000 to GM 7000, the fixed point crosshead is fitted to side panels on the trolley frame on bearing bushings using a laterally inserted bolt with cover.

 

Fixed point crosshead	Cover with rib screws
	Rope socket with rope wedge and dead end rope grip

   Inspect the fastening. The fixed point crosshead must be securely fastened and the bolt must be secured with a cover.

   Inspect the fixed point crosshead.

The drilled holes and the lower opening must not exhibit any cracking or other damage.

   Check bearing bushes for damage. The bearing bushes must not exhibit any cracking or other damage.

   If components are missing or damaged: replace the components.

   See Exchanging the fixed point crosshead with rope socket and rope wedge.