The regular inspection is performed at least once annually.
Under certain conditions, more frequent regular inspections may be necessary. Reasons include:
─ Frequent operation at the load capacity
─ Working in multiple shifts
─ Frequent use
─ Dusty or chemically aggressive environment
The end user is responsible for checking the requirements and determining the test intervals. ABUS will gladly assist you if questions arise.
The end user of the crane is responsible for the proper qualifications of the examiner.
|
Danger to persons! Persons can be injured if the test is performed incorrectly. If personnel other than that of the ABUS company are employed to perform the test, it is the end user's responsibility to ensure that these persons are adequately qualified. |
Examples of qualified persons:
─ Persons with comprehensive knowledge from specialist training in engineering and in the electrical systems of cranes.
─ Persons with sufficient experience in the operation, installation and maintenance of cranes.
─ Persons with comprehensive knowledge regarding the relevant technical rules, directives and safety regulations applicable in the respective country.
─ Persons receiving regular training from ABUS.
The regular inspection occurs in many countries because of national requirements and distinctions that must be observed accordingly.
In addition, the regular inspection is also the basis for maintenance work on the crane which is prescribed by ABUS as manufacturer.
If defects, wear or similar issues are noticed, this is the time to perform the corresponding maintenance work.
Based on this requirement, it can also be useful to adapt the test intervals (see At the start) or to inspect components subject to especially high load (see Testing of components subject to especially high stress).
As a manufacturer's requirement, the regular inspection must therefore also be performed by the end user if national requirements do not demand any regular inspection or these inspections are not as comprehensive.