Installing the slewing stop

Only with 3-sided support console

 

If a slewing stop is included in the delivery:

 

Rib screws	Slewing stop

   Screw the slewing stop (2x) onto the side bracket plate using rib screws (4x). 300 Nm.

 

 

Only with buffer rod

The buffer rod serves as the slewing stop for limiting the slewing range. With C-rail systems, they are only usable under certain conditions. The counterstop points are not included in the scope of delivery and are created on the customer side.

 

Buffer rod	Clamping plate with hexagon head screws
Hexagonal nut	Clamping angle

   Pre-assemble the clamping plates (2x) on the buffer rod with hexagon head screws (4x) and clamping angles (2x).

 

 

Buffer rod	Clamping plate with hexagon head screws
	Jib arm

   Lay the buffer rod with clamping angles and clamping plates on the jib arm.

   Push the buffer rod to bring it into the desired lengthwise or crosswise position on the jib arm.

   Perform the final bolting of the buffer rod at the desired position.

Hexagon head screws	Tightening torque
M12	83 Nm
M16	200 Nm