Installing the horn/lamp

A horn/lamp is installed on the square tube used to mount the receiver. The signal lamp lights up when the transmitter is logged into the receiver. The horn allows persons to be warned when the crane is being operated.

Only with radio remote control

This section only applies when the jib crane is operated using a radio remote control.

Installing the horn/lamp

The horn/lamp should be installed on the horizontal square tube on the jib arm. This ensures that the signal lamp protrudes out above the jib arm and can be seen from all sides.

HF/EF mounting	Horn/lamp

	Mounting plate

Screw the horn/lamp onto the mounting plate using fillister-head screws M5x12 (2x) and hexagonal nuts M5 (2x). 5 Nm.

Screw the mounting plate onto the HF/EF mounting using rib screws M8x16 (2x) and rib nuts M8 (2x). 23 Nm.

Screw the HF/EF mounting onto the horizontal square tube on the jib arm using threaded brackets M8 (2x). 23 Nm.