The following requirements must be met in order for the jib crane to be installed:

The requirements for installation of the jib crane can be examined by ABUS by means of a technical pre-clarification.

─     As a rule, the technical pre-clarification will be conducted in cases in which ABUS carries out the installation of the jib crane.

─     The technical pre-clarification can be carried out by ABUS at extra cost when the jib crane is installed by the user or by other installation companies.

─     If no technical pre-clarification is performed by ABUS, the following requirements must be independently checked and documented prior to the installation.

─     The requirements for installation of the pillar mounting (anchor rods, ideal anchor screws, dowel plates, intermediate plate on the floor of the building, intermediate plate on the hall ceiling) must be met.

See the product manual for pillar mounting.

─     All planning documents for the jib crane must be available.

These planning documents are created and calculated by ABUS individually for every single jib crane (or for the conversion of an existing jib crane).

─     The planning documents, above all the crane drawing, must be adhered to exactly in all cases.

If the foundation recommended by ABUS is adopted, the reinforcement plan produced by ABUS must also be executed.

Planning the foundation with the reinforcement plan can, however, also be produced on-site.