Inspecting the deflection roller crosshead

Only with wire rope hoist with hoist drive GM 5000 or GM 6000 with reeving 4/1

 

Bolt with SL safety clip	Bearing bush
Cover	Deflection roller

   Inspect the deflection roller crosshead.
The drilled holes must not exhibit any cracking or other damage.

   Inspect the deflection roller.
It must not exhibit any deep grooves or heavy wear.

If necessary, the deflection roller can be carefully inspected using a special template. Please contact ABUS Service for this. See ABUS Service.

   Bolts and SL safety clips must be in place and secured.

   Check bearing bushes for damage. The bearing bushes must not exhibit any cracking or other damage.

   If components are missing or damaged: replace the components.

See Exchanging the deflection roller crosshead.

 

 

Only with wire rope hoist with hoist drive GM 7000 and reeving 4/1

On the wire rope hoist with hoist drive GM 7000 and a reeving 4/1, the deflection roller crosshead is attached on the outside of the trolley frame.

 

   Inspect the deflection roller crosshead.
The drilled holes must not exhibit any cracking or other damage.

   Inspect the deflection roller.
It must not exhibit any deep grooves or heavy wear.

   Check the deflection roller crosshead suspension.

The suspension must be sufficiently lubricated so the deflection roller crosshead can move back and forth. See Deflection roller crosshead.

   Bolts and SL safety clips must be in place and secured.

   If components are missing or damaged: replace the components.

See Exchanging the deflection roller crosshead.