Attach the mount to the end carriage on which the crane panel is installed.

    Bolt the mount onto the threaded bracket.

    Slide on the two pipe clamps and secure them.

    If necessary, mount the signal lamps on the horizontal square tube as shown.

The white, yellow and green signal lamps are for the tandem control system. The red signal lamp is for the radio remote control.

    Mount the vertical square tube on the horizontal square tube.

    Screw the vertical square tube until hand-tight to the mount using the pipe clamps (2x).

    Route the connection cables from the signal lamps to the crane panel.

    Secure the connection cables with cable clips.

    Connect the signal lamps according to the wiring diagram in the crane panel.