Danger due to malfunction!
If the cross-type limit switch is screwed on too tightly, the parts on the inside can become jammed and no longer function properly.
The tightening torque of 3 Nm must be strictly observed.
If the cross-type limit switch is damaged, it must be replaced. The plug-in connection allows you to carry out the replacement without any wiring work.
|
|
Danger due to malfunction! If the cross-type limit switch is screwed on too tightly, the parts on the inside can become jammed and no longer function properly. The tightening torque of 3 Nm must be strictly observed. |
|
|
Coupling |
|
| |
|
Cable fitting |
Cover |
Unscrew and remove the screws (2x) on the cover.
Remove the cover.
Disconnect the coupler plug of the connecting cable from the circuit
board.
The cable fitting on the cover does not need to be unscrewed. The existing cover can be fitted with the attached connection cable to a new cross-type limit switch.
Insert the coupler plug onto the new cross-type limit switch.
Close the cover.
Tighten screws (2x). 3 Nm.
