In these parameters you enter the maximum load capacity of the respective hoists.

If the hoist is not present, no maximum load capacity needs to be entered in the corresponding parameter. In this case, the corresponding parameter has the value 0.

Note

Parameter P 3.0 cannot be set if a value is saved under P 5.11. If a value is saved in P 5.11, the LIS-SV is activated for operation with the ABULiner frequency converter. In this case, P 5.11 must first be set to 0. See product manual “ABULiner Lifting/Lowering”.

   Select the corresponding parameters with the arrow buttons.

─     P 1.0 for device's own hoist

─     P 2.0 for the hoist at input F2

─     P 3.0 for the hoist at input F3

   Press Enter briefly.

●   The parameter is opened.

   Enter the maximum load capacity of the respective hoist with the arrow buttons.

   Press Enter briefly.

●   The value is saved.