Installing the travel limit switch

Only with travel limit switch

 

The travel limit switch is mounted on one of the two side panels. It may be mounted on the same square tube as the power supply or on a separate square tube. It may also be mounted on a vertical or horizontal square tube.

 

	Switching lug
Travel limit switch

   Select the position of the travel limit switch so that the switching lug triggers the travel limit switch at a distance of 40 mm to 60 mm from the centre.

 

 

Danger due to malfunction! If the cross-type limit switch is screwed on too tightly, the parts on the inside can become jammed and no longer function properly. The tightening torque of 3 Nm must be strictly observed.

 

Mounting bracket	Threaded bracket
Cross-type limit switch

   Screw the mounting bracket onto the cross-type limit switch with the fillister-head screws M5x50 (2x).

   Screw on the mounting bracket using locking washers and M5 hex nuts (2x). 3 Nm.

   Insert threaded brackets (2x) in the mounting bracket.

   Loosely screw in the M8 rib nuts (4x).

 

 

Cross-type limit switch
	Rib nut

   Turn the travel limit switch to position 0.

The position of the cross-type limit switch is marked with an arrow that can be rotated further, depending on the switching state.

   Hold the travel limit switch against the square tube so that the switching lug activates the travel limit switch.

   Screw the travel limit switch onto the vertical square tube using pipe clamps (2x). Tighten to 15 Nm

 

 

   Lay the connection cable.

   Fasten the connection cable with cable ties, cable ducting and adhesive clips.