The qualified person inspecting the chain hoist is responsible for the type and scope of the test.

In addition to the points described here, all points outlined in the other supplied product manuals must also be checked.

The decision regarding the technically faultless condition of the chain hoist lies solely with the examiner. Any inadequacies, if found, must be eliminated. The examiner will decide if the chain hoist then requires additional testing.

If locally applicable regulations specify further tests, these are likewise to be carried out.

Additionally, at least the following points must be checked:

   Check the load hook. See page 29.

   Check the suspension bracket. See page 29.

   Check the condition of the chain. See page 30 and page 31.

   Check the friction clutch. See page 32.

   Check the air gap and brake lining thickness. See page 33.

   Check the lubrication of the chain. The chain may not be dry; lubricant must be visible on its surface. If it is not, lubricate the chain. See page 62.

   Check the installation of the chain. It may not be installed twisted. If it is, remove the chain and reinstall it so that it is free of any twisting.

   Check the C-link. It must be present and attached to the penultimate or third-last chain link in such a way that the opening, when installed, points in the direction of the inner fall (the fall under load). Otherwise, reinstall the C-link.

   Check the chain anchor point. The bolt must be inserted and secured. If it is not, push the bolt in and secure it with the SL safety clip.

   Test the deep groove ball thrust bearing on the load hook. It must turn easily and exhibit no damage. Otherwise, replace the deep groove ball thrust bearing.

Document the test:

   If the chain hoist is part of a crane installation: Document the results of the test in the test log book of the crane installation.

   If the chain hoist is operated independently: Document the results of the test in the test log book. See page 36.