Overrunning the switching points of the electronic hoist limit switch

Only with an electronic hoist limit switch

 

In some situations, it may be necessary to overrun a set switching point (upper or lower).

 

   Move to the switching point to be overrun until the load hook stops.

If the load hook is within about 10 cm of the switching point, the following sequence overruns the set switching point. Beyond this range, this sequence is used to set a switching point.

 

 

Control cable	Bayonet nut
Teach-in module

   Remove the pendant control.

   Insert the teach-in module.

   Wait at least 5 s.

   Remove the teach-in module.

 

   Only with pendant control with teach-in button: Instead of inserting the teach-in module, press and hold the teach-in button for 5 seconds.

   Only with ABURemote AC with teach-in: Instead of inserting the teach-in module, press and hold the “teach-in” direct access button (T with arrow) for 5 seconds.

 

 

Control cable	Bayonet coupling
Emergency stop button	Pendant control

   Only with teach-in module: Insert pendant control.

   Only with teach-in module: Unlock emergency stop button.

 

 

   Move the chain up or down over the set switching point.

●   The set switching point has been overrun.