For spacing buffers only
Spacing buffers can be installed when there are several trolleys on the crane. They prevent damage to the wire rope hoist if the trolleys collide.
They are installed on the mounting bars that are affixed to the flange plates.
Installing spacing buffers
|
Threaded plate for mounting bar |
Spacing buffer |
|
| |
|
|
Rib screw M12x25 |
Bolt the threaded plate loosely
to the spacing buffers using rib screws M12x25 (3x).
Turn the threaded plate on edge and
push the spacing buffers into the mounting bars from the side.
Moving the spacing buffers
|
Spacing buffer |
|
|
| |
|
Caps |
|
Push the spacing buffers into
the mounting bars.
Move the spacing buffers so that both exhibit the same distance to the middle of the main girder.
For a GM modular wire rope hoist and a GM compact wire rope hoist, install two spacing buffers. For two GM modular wire rope hoists, install one spacing buffer in the middle.
Tighten the rib screws to 25 Nm.
85 Nm.
Fit the caps (4x).