|
|
Danger of loads dropping due to lubricated brakes! If the hub on the brake of the hoist motor or travel motor is lubricated, the lubricant can run onto the brake lining and considerably impair the braking. This could cause the load to slip or delay the stopping of the crane. Do not lubricate the hubs on the brakes! |
|
|
Observe the product manuals! In addition to the points described here, all information in the section “Lubricants” in the other supplied product manuals also applies. |
Note:
Synthetic lubricants may not be mixed with mineral-based lubricants!
Disassemble the respective
components (travel drive, hoist drive,...) and lay them open.
Remove the old lubricant at
operating temperature.
Remove residual lubricant with a
suitable cleaning agent.
Refill or apply new
lubricant.
Reassemble the respective
components and check that they are sealed.
