If the crane is additionally equipped for radio remote control with a mobile control with pendant control, the pendant control can be used as necessary (e.g. when the radio transmitter is not available).

This requires that several bush multipoint connectors be reconnected in the crane panel.

Open the crane panel.

Find bush multipoint connector X2.

Detach bush multipoint connector.

The bush multipoint connectors from the pendant control have already been guided into the crane panel and laid ready there.

Insert bush multipoint connector from pendant control.

─     Bush multipoint connector X2.11 (terminal 1 to 5)

─     Bush multipoint connector X2.12 (terminal 6 to 15)

─     Bush multipoint connector X2.13 (terminal 16 to 27. Depending on the crane equipment, only individual terminals may be available and not all those described here)

─     Bush multipoint connector X2.14 (terminal 28 to 38. Depending on the crane equipment, only individual terminals may be available and not all those described here, or the bush multipoint connector may be entirely omitted)